您已在下面突出显示的字段中输入包含无效字符的值。 请仅使用有效字符修改您的选择。
产品可能与您的搜索条件并不完全匹配
您买过此产品。
在订单历史记录中查看
SN74LVC1T45QDCKRQ1
收发器, 74LVC1G145, 1.65 V至5.5 V, SC-70-6
- 制造商产品编号:
- SN74LVC1T45QDCKRQ1
- 库存编号
- 3006215
产品概述
The SN74LVC1T45QDCKRQ1 is a single-bit dual-supply Bus Transceiver with configurable voltage translation and 3-state outputs. This non-inverting bus transceiver uses two separate configurable power-supply rails. The A port is designed to track VCCA. VCCA accepts any supply voltage from 1.65 to 5.5V. The B port is designed to track VCCB. VCCB accepts any supply voltage from 1.65 to 5.5V. This allows for universal low-voltage bidirectional translation between any of the 1.8/2.5/3.3/5V voltage nodes. It is designed for asynchronous communication between two data buses. The logic levels of the direction-control (DIR) input activate either the B-port outputs or the A-port outputs. The device transmits data from the A bus to the B bus when the B-port outputs are activated and from the B bus to the A bus when the A-port outputs are activated. The input circuitry on both A and B ports always is active and must have a logic HIGH or LOW level applied to prevent excess ICC and ICCZ.
- Customer-specific configuration control can be supported along with major-change approval
- VCC Isolation - If either VCC input is at GND, both ports are in the high-impedance state
- DIR Input circuit referenced to VCCA
- IOFF Supports partial-power-down mode operation
- Fully configurable dual-rail design allows port to operate over the full 1.65 to 5.5V supply range
- ±24mA Output drive at 3.3V
- Green product and no Sb/Br
应用
工业, 车用
产品信息
技术文档 (0)
CAD 下载
--请选择...
✔
--请选择...
×
条款
CAD Models - Notice
CAD Models and drawings are provided to you on a revocable limited licence for your internal use only but remain the property of the manufacturer who retain all intellectual property rights and ownership. They are provided to assist you in decision making and as design guide but are not guaranteed to be error free, accurate or up to date and is not intended to be taken as advice.
Use of these CAD models and other options provided are downloaded and used entirely at your own risk and by continuing you confirm acceptance of the above.
包装类型
切割卷带
可延期交货
由于市场条件的影响，交货时间仅供一般指导，可能会在短时间内发生变化
筛选器工具