LT1016IS8#TRPBF

LT1016 is an UltraFast™ precision 10ns comparator that interfaces directly to TTL/CMOS logic while operating off either ±5V or single 5V supplies. Tight offset voltage specifications and high gain allow the LT1016 to be used in precision applications. Matched complementary outputs further extend the versatility of this comparator. A unique output stage provides active drive in both directions for maximum speed into TTL/CMOS logic or passive loads, yet does not exhibit the large current spikes found in conventional output stages. This allows the LT1016 to remain stable with the outputs in the active region which, greatly reduces the problem of output “glitching” when the input signal is slow moving or is low level. Application includes high speed A/D converters, high speed sampling circuits, line receivers, extended range V-to-F converters, fast pulse height/width discriminators, zero crossing detectors, current sense for switching regulators, high speed triggers, crystal oscillators.

• Complementary output to TTL, low offset voltage
• No minimum input slew rate requirement
• No power supply current spiking, output latch capability
• 1mV typical input offset voltage (RS ≤ 100 ohm, TA = 25°C, V+ = 5V, V- = 5V)
• 4µV/°C typical input offset voltage drift (RS ≤ 100 ohm, TA = 25°C, V+ = 5V, V- = 5V)
• Input voltage range from 1.25 to 3.5V (single 5V supply, TA = 25°C, V+ = 5V, V- = 5V)
• 96dB typical common mode rejection (-3.75V ≤ VCM ≤ 3.5V, TA = 25°C)
• 75dB typical supply voltage rejection (positive supply 4.6V ≤ V+ ≤ 5.4V)
• 10ns typical propagation delay (∆VIN = 100mV, OD = 5mV, TA = 25°C)
• 8 lead plastic SO package, operating temperature range from -40°C to 85°C

Notes

ADI products are only authorized (and sold) for use by the customer and are not to be resold or otherwise passed on to any third party