LT1081CN#PBF

LT1081 is a only dual RS232 driver/receiver with charge pump to guarantee absolutely no latchup. This interface optimized devices provide a realistic balance between CMOS levels of power dissipation and real world requirements for ruggedness. The driver outputs are fully protected against overload and can be shorted to ±30V. Unlike CMOS, the advanced architecture of this does not load the signal line when shut down or when power is off. Both the receiver and RS232 outputs are put into a high impedance state. An advanced output stage allows driving higher capacitive loads at higher speeds with exceptional ruggedness against ESD. Typical applications are portable computers, battery-powered RS232 systems, power supply generator, terminals, modems.

• Superior to CMOS, improved speed: operates over 120KBaud
• Improved protection: outputs can be forced to ±30V without damage
• Three-state outputs are high, impedance when off, only needs 1µF capacitors
• Absolutely no latchup, CMOS comparable low power is 60mW
• Logic input current is 20µA maximum (VIN ≥ 2V, TA=25°C)
• Output short-circuit current is 12mA typical (sourcing current, VOUT=0V, TA=25°C)
• Slew rate is 30V/µs maximum (RL=3K, CL=51pF, TA=25°C)
• 16-lead PDIP package
• Temperature rating range from 0°C to 70°C

Notes

ADI products are only authorized (and sold) for use by the customer and are not to be resold or otherwise passed on to any third party