5329

Robotics board for Raspberry Pi Pico. IT features 2 dual H bridge motor driver ICs. It is capable of driving 2 standard motors or 1 stepper motor each with full forward, reverse and stop control. There are also 8 servo outputs, capable of driving standard and continuous rotation servos. They can all be controlled by the Pico using the I2C protocol via a 16 channel driver IC. The IO break out provides connections to all the unused pins on the Pico. The 27 available I/O pins allow other devices such as sensors or ZIP LEDs to be added to the board.

• Feature-packed board designed to sit at the heart of your Raspberry Pi Pico robotics projects
• Board can drive 4 motors (or 2 stepper motors) w/ full forward, reverse, stop control and 8 servos
• Features 27 other I/O expansion points and Power and Ground connections
• I2C communication lines are also broken out allowing other I2C compatible devices to be controlled
• Additionally, the board features an on/off switch and power status LED
• Power the board via either a terminal block or servo style connector
• 3V and GND pins are broken out to solder pads, allowing external devices to be powered
• Code it with MicroPython via an editor such as the Thonny editor

注释

Note: Raspberry Pi Pico shown for illustration only, not included. For direct connection, requires the Pico to have male headers soldered to it (pins pointing down).