DRV8860PW

The DRV8860PW is a low-side Octal Driver with serial interface. It has built-in diodes to clamp turn-off transients generated by inductive loads and can be used to drive unipolar stepper motors, DC motors, relays, solenoids or other loads. A single channel can deliver up to 560mA continuous output current. A serial interface is provided to control the DRV8860 output drivers, configure internal setting register and read the fault status of each channel. This driver can be daisy-chained together to use a single serial interface. Energizing-time and holding-PWM-Duty cycles are configurable through serial interface as well. These functions allow for cooler running than always-on solutions. Internal shutdown functions are provided for over-current, short-circuit, under-voltage lockout and over-temperature protection. The driver does not include open load detection. Fault information for each channel can be read out through serial interface and indicated by an external fault pin.

• Eight NMOS FETs with over-current protection
• Integrated inductive catch diodes
• Serial interface
• Open/short load detection
• Configurable 100% output timing
• Configurable PWM duty cycle
• Input digital noise filter for noise immunity
• Internal data read back capability for reliable control
• Over-current Protection (OCP) protection
• Open Load Detection (OL)
• Over-temperature Shutdown (OTS)
• Under-voltage lockout (UVLO)
• Individual channel status report
• Fault condition alarm
• Green product and no Sb/Br

警告

This device has limited built-in ESD protection, leads should be shorted together or the device placed in conductive foam during storage or handling to prevent electrostatic damage to the MOS gates.